Weaving Wire Diameter Tolerances
The wire diameter tolerance before weaving shall be in compliance with the table below. Mechanical deformation of the wire occurs during the weaving process, therefore the wire diameter if measured after weaving, should only be interpreted as a guide to the original diameter prior to weaving.
Wire Diameter |
Tolerance |
||
| Inch | mm | Inch | mm |
| 0.500 and larger | 12,70 and larger | +/-0.0020 | +/-0,05 |
| Under 0.5000 to 0.3125 | Under 12,70 to 7,94 | +/-0.0015 | +/-0.04 |
| Under 0.3125 to 0.0440 | Under 7,94 to 1,12 | +/-0.0010 | +/-0,03 |
| Under 0.0440 to 0.0330 | Under 1,12 to 0,84 | +/-0.0008 | +/-0,02 |
| Under 0.0330 to 0.0240 | Under 0,84 to 0,61 | +/-0.0005 | +/-0,013 |
| Under 0.0240 to 0.0120 | Under 0,61 to 0,30 | +/-0.0004 | +/-0.010 |
| Under 0.0120 to 0.0080 | Under 0,30 to 0,20 | +/-0.0003 | +/-0,008 |
| Under 0.0080 to 0.0048 | Under 0,20 to 0,12 | +/-0.0002 | +/-0,005 |
| Under 0.0048 | Under 0,12 | +/-0.0001 | +/-0,003 |
Wire Diameter |
Tolerance |
||
| Inch | mm | Inch | mm |
| 0.500 and larger | 12,70 and larger | +/-0.0030 | +/-0,08 |
| Under 0.5000 to 0.0800 | Under 12,70 to 2,03 | +/-0.0020 | +/-0.05 |
| Under 0.0800 to 0.0350 | Under 2,03 to 0,89 | +/-0.0010 | +/-0,03 |
| Under 0.0350 to 0.0280 | Under 0,89 to 0,71 | +/-0.0008 | +/-0,02 |
| Under 0.0280 to 0.0200 | Under 0,71 to 0,51 | +/-0.0006 | +/-0,015 |
| Under 0.0200 to 0.0160 | Under 0,51 to 0,41 | +/-0.0005 | +/-0.013 |
| Under 0.0160 to 0.0110 | Under 0,41 to 0,28 | +/-0.0004 | +/-0,010 |
| Under 0.0110 to 0.0060 | Under 0,28 to 0,15 | +/-0.0003 | +/-0,008 |
| Under 0.0060 to 0.0045 | Under 0,15 to 0,11 | +/-0.0002 | +/-0,005 |
|
|
|
[Wire Cloth Screen Index] [Wire Mesh Products] [Screening Reference]
By using this website, you are agreeing that you have read and accepted the Terms of Use Agreement If you do not agree to these terms, please do not use this website. Copyright © 2009 Screen Technology Group, Inc. All Rights Reserved. Last modified: December 02, 2011
